Product ID:RHODORSIL FLUID 47V100 THROUGH 2500000
MSDS Date:02/15/1996
FSC:9150
NIIN:00-292-9608
MSDS Number: CGDXL

Emergency Phone: 800-424-9300(CHEMTREC)

Info Phone: 609-860-4000

Cage: 0A5D1

Telephone: 504-366-9105

Cage: 0PGK2

POLY (DIMETHYLSILOXANE)

CAS: 63148-62-9

RTECS: JJ6484500

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:NO Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYE:NON-IRRIT.MAY CAUSE FOREIGN BODY
IRRIT ONLY.SKIN:NON-IRRIT.LOW ACUTE DERM TOXICITY.INHAL:NOT
LIKELY.INGEST:LOW ACUTE ORAL TOXICITY.UNDER CERTAIN CONDITIONS THIS
PROD MAY GENERATE FORMALDEHYDE AS B YPRODUCT OF OXIDATIVE THERMAL
DECOMPOSTION.FORMALDEHYDE LISTED AS POT HUMAN CARC BY
IARC/OSHA/ACGIH.
Explanation of Carcinogenicity:PER MSDS:PROD DOESNT CONTAIN ANY INGRED
DESIGNATED BY IARC,NTP/ACGIH/OSHA AS PROBABLE OR SUSPECTED HUMAN
CARCINOGENS.
Effects of Overexposure:CAUSES FOREIGN BODY IRRIT ONLT.
Medical Cond Aggravated by Exposure:NON SPECIFIC INFORMATION FOUND.

First Aid:EYE:IMMED ABSORB EXCESS W/CLEAN ABSORB CLOTH/COTTON.HOLD
EYELIDS OPN,FLUSH W/STEADY GENTLY STREAM OF H2O FOR @LEAST
15MINS.IRRIT DEVLP/PERSIST/VISUAL CHANGES OCCUR SEEK MED
ATTN.SKIN:IMEMD WIPE EXCESS OFF W/DRY CLOTH.WASH W/PLENTY OF
SOAP/H2O.IRRIT DEVLP/PERSIST GET MED ATTN.INAHL:RESP IRRIT/DISTRESS
OCCURS REMOVE TO FRESH AIR.IRRIT/DISTRESS CONTS SEEK MED
ATTN.INGEST:CONSC/ALERT GIVE 1-2 (SUPPLE)

Flash Point Method:TCC
Flash Point:>572F,>300C
Autoignition Temp:Autoignition Temp Text:NP
Lower Limits:NO DATA
Upper Limits:NO DATA
Extinguishing Media:RECOMMENDED:DRY CHEMICAL, FOAM, CARBON DIOXIDE.
Fire Fighting Procedures:FIREFIGHTER SHOULD WEAR NIOSH/MSHA APPROV SCBA
& FULL PROTECTIVE CLOTH.COOL CNTNR EXPO TO FIRE W/WATER.
Unusual Fire/Explosion Hazard:FLAMM CLASS:WILL BURN.PRODUCT WILL BURN
UNDER FIRE CONDITIONS.

Spill Release Procedures:WEAR APPROP PROT GEAR FOR SITUATION.SEE PPE
INFO.CAUT:MATL MAY MAKE FLOOR SLIPPERY.DONT LEAVE TRACES OF PROD ON
FLOORS/LADDERS,ETC-SLIPPING HAZ.ABSORB W/INERT
ABSORBT.SCRAPEUP/PLACE IN APPRO CLSD CNTN R.CLEANUP RESIDUE
W/APPROP SOLVT-PAINT THINNER,
Neutralizing Agent:SPILL:MINERAL SPIRITS;PROVIDE GOOD VENTI/NO IGN
SOURCES.DONT FLUSH TO DRAIN.

Handling and Storage Precautions:MIN/MAX STORAGE
TEMP:5-25C/41-77F.AVOID DIRECT/PROL SKIN/EYE CONTACT.STORE IN
TIGHTLY CLSD CNTNR-MATL EPOXY COAT STEEL,ORD STEEL,POLYETHYLENE.
Other Precautions:PRODUCT CONTAINS DIMETHYLPOLYSILOXANE WHICH CAN
GENERATE FORMALDEHYDE AS BYPRODUCT OF OXIDATION THERMAL DECOMPO
BEGINNING @APPROX150C/300F.EXPO TO FORMALDEHYDE CAN CAUSE ADVERSE
EFFECTS(SKIN/RESP SENS ,EYE/THROAT IRRIT)& POT CANC HAZ.

Respiratory Protection:WHEN RESP REQUIRED SELECT NIOSH/MSHA APPROV
EQPMT BASED ON ACTUAL/POT AIRBONRE CONE & IAW LATEST OSHA STD
(29CFR1910.134) &/OR ANSI Z88.2 RECOMMENDATIONS.FOR REASONABLY
FORESEEABLE INDUSTRIAL END USES OF MATL RESP PROT SHOULDNT BE
NECESSARY
Ventilation:WHERE ENGINEER CNTRL INDICATED BY USE CONDITIONS/POT FOR
EXCESSIVE EXPO EXIST:GEN AREA DILUTION/EXHAUST VENTILATION.
Protective Gloves:GLOVES
Eye Protection:ANSI Z87 APPROV EQPMT FOR PARTICULAR USE
Other Protective Equipment:SUITABLE LONG-SLEEVED
CLOTH(SHIRTS,PANTS).SKIN PROTECTION:CONSIDERATION MSUT BE GIVEN TO
DURABILITY & PERM RESIST.
Work Hygienic Practices:ITS GEN REGARDED AS GOOD PRAC TO WEAR MIN SAF
GLASSES W/SIDE SHIELDS WHEN WORK IN INDUSTR ENVIRO.WASH HAND/FC AFT
HNDLG.
Supplemental Safety and Health
1STAID:GLASSES OF H2O TO DRINK.DONT GIVE ANYTHING BY MOUTH IF
UNCONSC.SEEK MED ATTN.DONT LEAVE UNATTENDED.DR:ALL TREAT SHOULD BE
BASED ON OBSERVED SIGNS/SYMPT OF DISTRESS IN VICTIM.CONSIDERATION
SHOUL D BE GIVEN TO PROSSIBLITY THAT OVEREXPOTO MATLS OTHER THAN
THIS PROD MAY HAVE OCCURED.TREAT SYMPT.NO SPEC ANTIDOTE AVAI

HCC:V6
Boiling Pt:B.P. Text:N/DATA AVAI
Melt/Freeze Pt:M.P/F.P Text:N/DATA AVAI
Decomp Temp:Decomp Text:NP
Vapor Pres:<0.01@200C
Vapor Density:N/DATA AVA
Spec Gravity:>0.96
pH:NA
Viscosity:NP
Evaporation Rate & Reference:NP
Solubility in Water:INSOLUBLE
Appearance and Odor:CLEAR VISCOUS LIQUID, ODORLESS
Percent Volatiles by Volume:NP
Corrosion Rate:NP

Stability Indicator/Materials to Avoid:YES
STRONG BASES,STRONG ACIDS,STRONG OXIDIZING AGENTS
Stability Condition to Avoid:HEAT, OPEN FLAME, SPARK.
Hazardous Decomposition Products:OXIDA/THERM:FORMALDEHYDE.OXIDES OF
CARBON,SILICA-(CRYSTALLINE).THERMAL:DIEMTHYLCYCLOSILOXANES,METHYLPH
ENYLCYCLOSILOXANES

Waste Disposal Methods:CHEM ADDN/PROCESS/ALTER MATL MAY MAKE WASTE
MANAGEMENT INFO IN MSDS INCOMPLETE/INACCURATE/INAPPROPR.STATE/LOC
REQMTS MAY BE MORE RESTRICTIVE/DIFF FRM FED LAW/REG.CONSULT
STATE/LOC REGS FOR PROPER DISP O OF MATL.CNTNR/EQPMT SHOULD BE
DECONTAM IMMED.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.